Impressivei thought me using the on-board(when present) speaker amp chip as standalone amp was clever.this is much much better!PS: to use the amp chip alone only connect 12v and not the others, then just probe input and jumper to an input jack, then just desolder or cut traces if signal gets eaten up by passives/dsp-output.i have seen just ONE card that defaults to having line-in turned on and up before communication with host. Finally, we get a look at a proper schematic at the four minute mark which details the pull-up resistors, hardware reset circuit, and the optoisolator he added for the MIDI connections themselves.Thanks Gnif.Posted in Tagged, Post navigation. ![]() ![]() The image above is found at about 2:35 seconds and about twenty seconds later you get a look at how he patched into the conductors on the edge connector on both sides followed by the MIDI in and out connections. By today’s standards the almost twenty year old card isn’t all that powerful, but it is interesting to.Benji Kimba posted the video overview of his project which you can watch after the break.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |